6 × 24 mm Dowel Pin — Stainless 17-4 H900
Precision turned to order in Stainless 17-4 H900. Precipitation-hardened stainless in its highest-strength condition.
Price
| Quantity | Per piece | Order total |
|---|---|---|
| 10 | $21.89 | $218.90 |
| 25 | $12.75 | $318.75 |
| 50 | $9.69 | $484.50 |
| 100 | $8.12 | $812.00 |
| 250 | $6.87 | $1717.50 |
| 500 | $6.22 | $3110.00 |
| 1,000 | $5.72 | $5720.00 |
Prices last updated —.
Specification
| Diameter | 6.000 mm (0.2362") |
| Diameter tolerance | H7 (±0.012 mm) (ISO shaft grade h7) |
| Length | 24.000 mm (0.9449") |
| Length tolerance | ±0.1 mm |
| Material | Stainless 17-4 H900 |
| Ends | 45° chamfer both ends, or full radius — configurable |
| Weight per piece | 0.01168 lb |
Lead time
- Rush (2–3 days)
- Expedited (5–7 days)
- Standard (10–14 days)
About this size
Pins in this range are the workhorses of fixture and tooling work — locating plates, indexing sub-assemblies, and holding alignment through repeated teardown. There is enough cross-section here to take real side load, so the usual failure mode is a worn or bell-mouthed hole rather than the pin. If a fixture is opened often, a slip fit in one half and a press fit in the other saves the hole.
17-4 PH in the H900 condition is the choice when a stainless pin has to be strong rather than merely corrosion resistant. Precipitation hardening gives it strength approaching alloy steel while keeping usable corrosion performance, which suits instrument mechanisms and load-bearing locating pins. H900 is the highest-strength and least ductile of the aging conditions, so it favours shear duty over anything that wants to flex.
Specified in millimetres, the diameter tolerance is computed as an ISO 286-1 IT band rather than a fixed figure, so it tightens as the diameter falls — a 2 mm pin at h7 is held far closer in absolute terms than an 8 mm one at the same grade. Grades h5 through h8 are offered in metric, all of them shaft tolerances that fall at or below the nominal diameter. Which grade a given assembly needs is the designer's call, and the configurator prices each of them so the choice can be made against real numbers.
Need a different length?
This page prices a 24.000 mm pin, but the length is not fixed. The same 6.000 mm diameter is turned to order at any length between 0.508 mm and 101.6 mm — enter the one you need and the price updates immediately.
That is usually the reason to have a pin made rather than bought. A standard pin comes in standard lengths, so an odd length means cutting one down, which leaves a raw end to re-finish and puts the length tolerance at the mercy of whatever did the cutting. A pin turned to length arrives finished on both ends and held to ±0.1 mm. More on that on the custom length dowel pins page.
Order this pin
Open the configurator with this specification already filled in — adjust the ends, tolerance grade, quantity or lead time, and check out.
Configure 6 × 24 mm Dowel Pin →
Other Stainless 17-4 H900 sizes
This size in other materials
All Stainless 17-4 H900 dowel pins · All sizes and materials
← Back to the instant quote