0.3750" × 1.5000" Dowel Pin — Stainless 17-4 H900
Precision turned to order in Stainless 17-4 H900. Precipitation-hardened stainless in its highest-strength condition.
Price
| Quantity | Per piece | Order total |
|---|---|---|
| 10 | $31.52 | $315.20 |
| 25 | $22.19 | $554.75 |
| 50 | $19.02 | $951.00 |
| 100 | $17.35 | $1735.00 |
| 250 | $15.62 | $3905.00 |
| 500 | $14.49 | $7245.00 |
| 1,000 | $13.50 | $13500.00 |
Prices last updated —.
Specification
| Diameter | 0.3750" (9.525 mm) |
| Diameter tolerance | ±0.0005" (ISO shaft grade h7) |
| Length | 1.5000" (38.100 mm) |
| Length tolerance | ±0.005" |
| Material | Stainless 17-4 H900 |
| Ends | 45° chamfer both ends, or full radius — configurable |
| Weight per piece | 0.04672 lb |
Lead time
- Rush (2–3 days)
- Expedited (5–7 days)
- Standard (10–14 days)
About this size
At the upper end of the range, dowel pins are structural as much as locational: they carry shear between plates that bolts only clamp. Removal becomes a design consideration at this size, so a blind hole wants either a tapped extraction thread or a through hole to push against. Pins this size are also stiff enough that hole alignment between mating parts matters more than the pin tolerance does.
17-4 PH in the H900 condition is the choice when a stainless pin has to be strong rather than merely corrosion resistant. Precipitation hardening gives it strength approaching alloy steel while keeping usable corrosion performance, which suits instrument mechanisms and load-bearing locating pins. H900 is the highest-strength and least ductile of the aging conditions, so it favours shear duty over anything that wants to flex.
Specified in inches, this pin is turned to a fixed shop band rather than a computed ISO grade: h8 holds a thousandth, h7 half a thousandth, and h6 two tenths. That is usually how a US drawing calls out a locating pin, and it keeps the tolerance conversation in the same units as the hole it goes into. Inch stock also tends to be what a domestic shop already has on the shelf, which shows up in the lead time more than in the price.
Need a different length?
This page prices a 1.5000" pin, but the length is not fixed. The same 0.3750" diameter is turned to order at any length between 0.02" and 4" — enter the one you need and the price updates immediately.
That is usually the reason to have a pin made rather than bought. A standard pin comes in standard lengths, so an odd length means cutting one down, which leaves a raw end to re-finish and puts the length tolerance at the mercy of whatever did the cutting. A pin turned to length arrives finished on both ends and held to ±0.005". More on that on the custom length dowel pins page.
Order this pin
Open the configurator with this specification already filled in — adjust the ends, tolerance grade, quantity or lead time, and check out.
Configure 0.3750" × 1.5000" Dowel Pin →
Other Stainless 17-4 H900 sizes
This size in other materials
All Stainless 17-4 H900 dowel pins · All sizes and materials
← Back to the instant quote