0.0625" × 0.2500" Dowel Pin — Stainless 17-4 H900
Precision turned to order in Stainless 17-4 H900. Precipitation-hardened stainless in its highest-strength condition.
Price
| Quantity | Per piece | Order total |
|---|---|---|
| 10 | $16.76 | $167.60 |
| 25 | $7.72 | $193.00 |
| 50 | $4.71 | $235.50 |
| 100 | $3.19 | $319.00 |
| 250 | $2.20 | $550.00 |
| 500 | $1.81 | $905.00 |
| 1,000 | $1.57 | $1570.00 |
Prices last updated —.
Specification
| Diameter | 0.0625" (1.587 mm) |
| Diameter tolerance | ±0.0005" (ISO shaft grade h7) |
| Length | 0.2500" (6.350 mm) |
| Length tolerance | ±0.005" |
| Material | Stainless 17-4 H900 |
| Ends | 45° chamfer both ends, or full radius — configurable |
| Weight per piece | 0.00022 lb |
Lead time
- Rush (2–3 days)
- Expedited (5–7 days)
- Standard (10–14 days)
About this size
At this diameter a dowel pin is doing delicate work: locating a lens cell, aligning the halves of a small instrument housing, or acting as a hinge pin in a hand-held device. Pins this fine are easy to bend during assembly, so the receiving holes want to be on-size and square, and press fits want an arbor rather than a hammer. Handling is usually the limiting factor rather than the pin itself.
17-4 PH in the H900 condition is the choice when a stainless pin has to be strong rather than merely corrosion resistant. Precipitation hardening gives it strength approaching alloy steel while keeping usable corrosion performance, which suits instrument mechanisms and load-bearing locating pins. H900 is the highest-strength and least ductile of the aging conditions, so it favours shear duty over anything that wants to flex.
Specified in inches, this pin is turned to a fixed shop band rather than a computed ISO grade: h8 holds a thousandth, h7 half a thousandth, and h6 two tenths. That is usually how a US drawing calls out a locating pin, and it keeps the tolerance conversation in the same units as the hole it goes into. Inch stock also tends to be what a domestic shop already has on the shelf, which shows up in the lead time more than in the price.
Need a different length?
This page prices a 0.2500" pin, but the length is not fixed. The same 0.0625" diameter is turned to order at any length between 0.02" and 4" — enter the one you need and the price updates immediately.
That is usually the reason to have a pin made rather than bought. A standard pin comes in standard lengths, so an odd length means cutting one down, which leaves a raw end to re-finish and puts the length tolerance at the mercy of whatever did the cutting. A pin turned to length arrives finished on both ends and held to ±0.005". More on that on the custom length dowel pins page.
Order this pin
Open the configurator with this specification already filled in — adjust the ends, tolerance grade, quantity or lead time, and check out.
Configure 0.0625" × 0.2500" Dowel Pin →
Other Stainless 17-4 H900 sizes
This size in other materials
All Stainless 17-4 H900 dowel pins · All sizes and materials
← Back to the instant quote